The factory color and location of wires car Concorde 1994 issue ELECTRICAL CIRCUIT COLOR POLARITY LOCATION
12 VDC | red | positive | a steering column |
starter | yellow | positive | a steering column |
ignition | blue | positive | a steering column |
Ignition # 2 | red / white * | positive | in the steering column to the right |
Heating fan | black / orange | positive | a steering column |
In-salon lighting | Yellow reddish-brown | Negative Negative | pedal cover on the driver side Fuse panel |
parking lights | black / yellow | positive | foot compartment on the driver side |
limit switch trunk / hatch | reddish-brown / black | Negative | foot compartment on the driver side |
unlocking the trunk / hatch | black / white | positive | foot compartment on the driver side |
door switch | reddish-brown | Negative | limit switch driver's door |
door lock | orange / purple | positive | for panel fuses |
Unlocking the doors | pink / purple | positive | for panel fuses |
lock / unlock doors ** | orange / purple | positive | foot compartment on the driver side |
Disarming alarm standard | green / orange | Negative | for panel fuses |
stoplight | white / red-brown | positive | a stop lamp switch |
tachometer | black or gray | | Ignition Coil Module |
lifting the left front window | blue / gold point | reverse | switch on the driver side |
lowering of the left front window | white / gold point | reverse | switch on the driver side |
lift the right front window | brown / white | reverse | switch on the driver side |
lowering the right front window | purple / white | reverse | switch on the driver side |
lift the left rear window | blue / white | reverse | switch on the driver side |
lowering of the left rear window | red / black | reverse | switch on the driver side |
lift the right rear window | gray / black | reverse | switch on the driver side |
lowering the right rear window | green / white | reverse | switch on the driver side |
Notes:* The red / white wire should be appearing +12 V voltage
remote start system in order to avoid
Tanning LED malfunction airbag.
** Alternative: Single-wire system lock / unlock. Use 2,7-kiloomny resistor to lock and 620-ohm resistor for unlock.
Arming regular alarm after installation
Remote engine startOn the model Chrysler Concorde 1994 issue nominal alarm will stand on
guard without the remote control by pressing the lock button on the
driver's door when it opened. With collapse of the nominal door alarm
activated. The following diagram provides arming factory alarm if
installed remote engine start.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة]Note:To disarm the factory system with remote start, with no special wires
to disarm, use the same scheme of the relay and connect the terminal 86
to a positive outlet opening and a contact 87 to the green / orange
wire behind the panel
fuses.
18.08.1999